Introduction
In this blogpost you will find a explanation of how to install a Operating system on your Intel Galileo gen 2 and how to install wifi on it using a PCIexpress card on the back of the Intel Galileo.
First of all why linux? We tried to install the windows stripped down version on the Intel Galileo, it was actually very easy to communicate to the Intel Galileo this way but after installing the drivers for the PCIexpress card on the windows we noticed that the stipped down version of windows didn't have a Bluetooth or Wifi stack. This makes it impossible to use the wifi and bluetooth from the PCIexpress card.
What hardware do you need?
U need an Intel Galileo Gen 2, SD card, ethernet cable, PCIexpress card preferable an Intel® Centrino® Advanced-N 6235 and a usb cable to connect the Galileo to your computer.
Installing Linux (Yocto)
To install the linux version for the Intel Galileo it is recommended that you take Yocto, but you can choose whatever you like.
Download:
https://software.intel.com/en-us/iot/downloads
After the download is completed you need to unpack this zip file and copy all the files from it to your micro SD card. This only takes around 5minutes.
You can now insert the card into the micro SD card slot on your Intel Galileo board. When you power up your board, the board automatically boots using the image on the card.
You can use a serial cable to usb, this is the easiest way to communicate to your Intel Galileo but you can also use an ethernet cable to do so.
Serial cable
Open a serial connection session with your board. Enter the following:
- cat /etc/version
- The Yocto image version is displayed in YYYYMMDDHHMM format. If your board is booting from its default image instead of the image you just downloaded, the version reflects an older date, such as201410101603
You should see a more recent image version, such as 201502260041.
Ethernet cable
If you want to communicate with your Galileo through ethernet connection you should do the following steps:
- You can connect your Galileo to your own network, make sure you plug in your ethernet cable from your computer into the same network. And you need to disable your wifi connection.
- If you are on the same network as your Galileo then you need to find out what IP adress your Galileo has. You can find this by running a tracking software like Zenmap. You should look for the name "intel corporation" and it should have the same mac-adres as your Galileo has. Now you should now the IP adress of your Galileo.
- After that you need to upload the sketch below to your Galileo.
#include <Ethernet.h>
void setup() {
// put your setup code here, to run once:
system("telnetd -l /bin/sh");
system("ifconfig eth0 10.31.133.234 netmask 255.255.0.0 up");
system("sudo service ssh start");
}
void loop() {
// put your main code here, to run repeatedly:
}
- Make sure to adjust the IP adress to your Galileo his IP adress.
- After you uploaded the sketch you could make connection with your Galileo through SSH. To make connection with your Galileo you need to have a program installed that can make that happen. Putty is a very good example of such a program. The Galileo will ask for a username or something like that, here you need to type root and no password.
- When you are connected through SSH you can start with configuring your PCIe card.
Installing WIFI on your Galileo
After downloading you need to copy the zipped file to your SD card, you should make an TMP folder where you can paste the file into.
